Milwaukee 2135-20 M18 ROCKET LED Tower Light & Charger

(1 customer review)

$519.00

In stock

Description

Milwaukee 2135-20 M18 ROCKET LED Tower Light & Charger

Milwaukee 2135-20 M18 ROCKET LED Tower Light & Charger – stand up; light up; charge up

  • Setup in 5 seconds
  • Extends up to 7 ft.
  • Collapses down to 4 ft. for transport and storage
  • Delivers up to 3,000 Lumens of TRUEVIEW™ High Definition, Multidirectional Light
  • Impact Resistant
  • Reinforced Legs
  • Built in M18™ Charger
  • Integrated AC Plug-in for running the light and charging M18 REDLITHIUM™ batteries
  • 3 Independently Pivoting Light Heads for casting light in multiple directions
  • Protective Guard secures both head and lens during transport and storage
  • Compact footprint
  • Low Center of gravity for greater stability
  • Low Battery indicator
  • Battery voltage and chemistry: 18V Lithium Ion
  • Length: 9″
  • Height: 41.5″
  • Width: 9.5″
  • Weight: 18 lbs
  • Tool warranty: 5 years
Light Settings and Run Times (with optional XC5.0Ah Battery)
Setting Light Intensity Run Time
High 3,000 lumens Over 2 hours
Medium 1,700 lumens Over 4 hours
Low 900 lumens 8 hours

 

Includes:

  • M18 ROCKET™ LED Tower Light/Charger (Tool Only) (2135-20)

Also available as a kit with 9.0Ah battery: 2135-21HD

Carry bag available (sold separately): 48-55-2135

Click here for more Milwaukee job lights.

Additional information

Weight 18 lbs
18V Power Tools

Brand Name

1 review for Milwaukee 2135-20 M18 ROCKET LED Tower Light & Charger

  1. a

    I love this. The tripod doesn’t hog a huge radius due to the devices low center of gravity, which means you get get it into tighter spaces (and you might not even need to deploy the tripod in some cases). And the tripod lifts the device about an inch off the ground to protect it from water etc. For some reason, the manual recommends turning the light off before unplugging it, but this is not always convenient when performing electrical work, so it would be nice if the design did not require this recommendation (whatever the reason). I did have to tighten one of the extension rod clamps with a screwdriver because it was not holding in place, but not big deal. Accidentally looking at the LEDs will impair your vision with 12 tiny dots for a few minutes, I wish the LEDs were covered with a fogged plastic to help reduce this effect. Also, raising the LEDs out of their housing is a little awkward, I wish there was a handle to pull them by rather than having to push them up from under the housing. Overall though, great purchase, although I wish it were cheaper.

Add a review

Your email address will not be published. Required fields are marked *